Download Center
1. To calibrate the ProxiLAB in PICC emulator mode using the SC-ProxiLAB-PICC-Probe+ follow this procedure:
Hardware configuration:
o Connect SC-ProxiLAB-PICC-Probe+ on the ProxiLAB (EXT.) using a HDMI cable.
o Connect the demodulator probe (CALIBRATION COIL 2, PCD Probe 1 or other probes) to the SC-ProxiLAB-PICC-Probe+ (J7 RF) using a SMA-SMA cable.
o Connect the SC-ProxiLAB-Poller0 (J1 IN) on the ProxiLAB output (ANT.) using a SMA-SMA cable.
o Place the demodulator probe on the SC-ProxiLAB-Poller0.
In RGPA software:
o Connect the ProxiLAB tool.
o In Settings->General : select PICC Emulator (Type A, B) in Smart card interface source section, then click on Default in Pre-Configuration section.
o In Settings->Emulator : uncheck Type B.
o In Settings->General : Select External - Probe in Demodulator calibration section as shown on the Picture 1.
o Click on Run calibration and click OK on the pop-ups.
Hardware configuration:
o Disconnect the demodulator probe from the SC-ProxiLAB-PICC-Probe+ (J7 RF)
o Connect the demodulator probe on the ProxiLAB input (PROBE) using a SMA-SMA cable.
The ProxiLAB is ready to be used in the test suite.
2. To calibrate the ProxiLAB in PICC emulator mode using the SC-ProxiLAB PICC-Probe follow this procedure:
Hardware configuration:
o Connect SC-ProxiLAB PICC-Probe on the ProxiLAB (EXT.) using a HDMI cable.
o Connect the SC-ProxiLAB-Poller0 (J1 IN) on the ProxiLAB output (ANT.) using a SMA-SMA cable.
o Place the SC-ProxiLAB PICC-Probe on the SC-ProxiLAB-Poller0.
In RGPA software:
o Connect the ProxiLAB tool.
o In Settings->General : select PICC Emulator (Type A, B) in Smart card interface source section, then click on Default in Pre-Configuration section.
o In Settings->Emulator : uncheck Type B.
o In Settings->General : Select External - Probe in Demodulator calibration section as shown on the Picture 1.
o Click on Run calibration and click OK on the pop-ups.
The ProxiLAB is ready to be used in the test suite.
Picture 1:
