This latest NomadLAB software release 1.18 offers the following improvements and fixes since NomadLAB 1.14:

New:

• PICC presence check method implemented in PICC Emulator
• NomadLAB.Display.OutputFile property implemented

 
Improvements:

• Administrator mode is not required anymore to update NomadLAB licenses with a .key file.
• The ICC emulator can distinguish cold and warm reset sequences and send dedicated ATR

 
Fixes:

• Bootloader mode not usable
• When SetWtxMute property is set the PICC emulator stops sending S_Block WTX requests, and sends the I_Block response when it's ready
• ProtocolType property configures the PICC emulator to support or not ISO/IEC 14443-4 in both types A and B
• EDC is shown correctly in RGPA description viewer
• The warning "Bits b4-b7 shall be set to 0, all other values are RFU" was wrongly displayed for ATR_RES frames in ISO18092 protocol.
• The warning "Bit b4 of PCB is set but CID is not present" was wrongly displayed in ISO14443 protocol.
• The warning "NVB is not set accordingly to the number of bits transmitted" was wrongly displayed on ANTICOLLISION frame.
• JISX6319: Some Write commands were analyzed as UNDECODED FRAME even though they were correctly formatted.
• Some ISO14443 Type B frames were mistakenly decoded as Innovatron (B prime) frames
• Default WTX response time was superior to the default FWT time
• Incorrect FDT in layer 4 of ISO14443 type A
• Wrong FDT in description panel
• Missing bytes in data column of list view
• RST channel was not created for ISO7816 protocol
• VCC channel had only two states instead of three
• Number of Demo trace was not equal to 20
• Memory management problem caused the corruption of spied data
• Protocol management error: NomadLAB should not respond to a PPS sent after a PPS request with a wrong CRC

 

Please contact our support team for more information .